Table of Contents
Advertisement
OPC8017 OPC8024 / OPD8017 OPD8024
8 Operation
8.1 Switching on and off
ATTENTION
Damage to the electronics!
The electronics can be damaged if the device is switched off and then on again too quickly.
After switching off and before switching on you must wait for at least 5 seconds!
Switch on the device by connecting the power adapter to the external power supply.
If an operating system (Windows or Linux) is installed, it now starts.
When the device is on, the status LED of the monitor lights up. This LED is on the front at the bottom
right.
Switch off the device by shutting down the operating system.
8.2 Multifunction touch-screen
Recommendation for use:
The touch calibration data is stored independent of the operating system and requires
no additional calibration by the user.
Recommendation for use:
With older operating systems, a driver may be required for the touch-screen
functionality.
Operate the multifunction touch-screen using up to 10 fingers. It is not only possible to tap
elements – swiping and dragging movements are also possible.
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
42
Advertisement
Table of Contents
