Table of Contents
Advertisement
OPC8017 OPC8024 / OPD8017 OPD8024
ATTENTION
Damage caused by heat!
If an unsuitable installation housing is selected, this can result in excessive heat generation.
When selecting the installation housing, the total power dissipation of the system including
installed PCBs must be taken into account. The max. permissible ambient temperature must
not be exceeded.
Recommendation for use:
Connect the power supply using a screw connection. For additional earthing to an
earthing screw, use a wire with a cross section of at least 2.5 mm².
This device is designed for integration. For installation and operation reasons (connector access), the
installation location must be accessible from the rear. The wall thickness of the installation location
must be between 2 and 13 mm. We recommend at least 3 mm for proper installation with IP65 on the
front.
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
21
Advertisement
Table of Contents
