Table of Contents
Advertisement
OPC8017 OPC8024 / OPD8017 OPD8024
2.3.2 Environmental conditions
ATTENTION
Damage caused by condensation!
If the temperature of the device is different to that of the room in which it is located, condensation
can form.
ATTENTION
Damage caused by heat!
If the device is exposed to sunlight or any other light or heat source, it can overheat and suffer
damage.
ATTENTION
Damage caused by heat!
If the device is installed in a panel, casing or similar, heat accumulation can occur.
Make sure that heat can be dissipated from the device!
The device can be put into operation and used under the following environmental conditions. Failure to
observe any one of these conditions will invalidate the warranty of the device. ADS-TEC cannot be
held liable for any damages arising from improper use and handling.
Use of the device is only permitted
-
in enclosed buildings
-
in non-explosive atmospheres
-
at altitudes below 3000 m
-
in environments with maximum contamination grade 2 (IEC/EN 61131-2)
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
14
Advertisement
Table of Contents
