Table of Contents
Advertisement
25
OPC8017 OPC8024 / OPD8017 OPD8024
Figure 10: Tightening clamping blocks, step 3
Then tighten all threaded pins to a torque of 0.5 Nm in the same sequence.
The pressure of the clamping block against the wall stabilises the OPC/OPD. Installation of the device
is complete when all clamping blocks are properly clamped.
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
Advertisement
Table of Contents
