Setting Default Units - Ametek Chatillon CS1100 User Manual

Enter the required user name then press on the ENTER button. Press on the "NewUser"
entry in the Password column to display an alphanumeric keypad. Enter the required
password then press on the ENTER button.
Note that this operator is only allowed to select and run predefined tests unless the
Supervisor checkbox is selected, when all features are accessible.
Repeat this procedure for all required operators, ensuring that at least one operator is
defined as a supervisor.
The "Initial Log-in" must now be changed to prevent unauthorized access. Press on the
"blank Password" entry at the top of the Password column to display an alphanumeric
keypad. Enter a suitable Master password then press on the ENTER button.
If an operator is entered in error, or has to be removed at a later date, press on the
unwanted user name then press the "DELETE" button.
Press on the "CLOSE" button to return to the "CONFIGURATION" screen.
The Force Tester can now only be used after a user has logged on using a defined User
Name and Password.
If a Supervisor password has been created, please ensure that this password is
remembered, or securely stored for future reference, because AMETEK is not
responsible for lost passwords.

4.3 SETTING DEFAULT UNITS

The "Global Default Units" are displayed on the right hand side of the screen. Whenever a
new test is performed, all test results will be reported in these units. Note that the result
units can always be changed whenever the test results are displayed.
To change a default unit, press the relevant button to cycle through the available units.
The Force button provides units of N, gf, kgf, lbf and ozf.
The Speed button provides units of mm/min and in/min.
The Distance button provides units of mm and in.
32 CS User Manual