Overview Overview INTRODUCTION The footswitch can significantly improve the speed at which data collection takes place by allowing the operator to focus on the task without needing to click a mouse button or press a key on the keyboard. The actual use of the footswitch is application dependent, and is documented in the manual that accompanied your Crystal Engineering software package.
Instructions Instructions INSTALLATION & SETUP The foot switch comes in two pieces. The Control Module, which has an attached USB cable and two 1/8" sockets, and the Foot Switch, which has an attached cable ending in an 1/8" plug. Note: When connecting the Foot Switch to a computer for the first time, it is best to connect it after your computer has booted up and is logged in.