Lower Anchor Pin - Ametek Chatillon CS1100 User Manual

5.3 LOWER ANCHOR PIN

The force tester is supplied with a Lower Anchor Pin assembly which is fitted to the "T" slot
table using two 5mm countersunk bolts.
If the Lower Anchor Pin is to be used, it should be adjusted so that it is accurately aligned
with the pin on the attached load cell. Carefully drive the crosshead downwards, using the
jog keys, until the load cell eye end is just above the lower anchor pin. Loosen the 2 fixing
bolts using the 5mm hexagonal key provided. Align the lower anchor pin to the load cell
anchor pin and then re-tighten the 2 fixing bolts.
40 CS User Manual