T0 (D0 Output Timeout); T1 (D1 Output Timeout); T2 (D2 Output Timeout) - Digi XBee User Manual

AT commands
Note Minimum firmware version required: 1.xA0. Firmware versions are numbered in hexadecimal
notation.
Parameter range
0 - 0xFFFFFFFFFFFFFFFF
Default
0xFFFFFFFFFFFFFFFF

T0 (D0 Output Timeout)

Sets or displays output timeout values for lines that correspond with the D0 parameter. When the
output is set (due to I/O line passing) to a non-default level, a timer starts that sets the output to its
default level when it expires. The timer resets when a valid I/O packet is received.
The Tn parameter defines the permissible amount of time to stay in a non-default (active) state. If Tn
= 0, Output Timeout is disabled (output levels are held indefinitely).
Note Minimum firmware version required: 1.xA0. Firmware versions are numbered in hexadecimal
notation.
Parameter range
0 - 0xFF (x 100 ms)
Default
0xFF

T1 (D1 Output Timeout)

Sets or displays output timeout values for lines that correspond with the D1 parameter. When the
output is set (due to I/O line passing) to a non-default level, a timer starts that sets the output to its
default level when it expires. The timer resets when a valid I/O packet is received.
The Tn parameter defines the permissible amount of time to stay in a non-default (active) state. If Tn
= 0, Output Timeout is disabled (output levels are held indefinitely).
Note Minimum firmware version required: 1.xA0. Firmware versions are numbered in hexadecimal
notation.
Parameter range
0 - 0xFF (x 100 ms)
Default
0xFF

T2 (D2 Output Timeout)

Sets or displays output timeout values for lines that correspond with the D2 parameter. When the
output is set (due to I/O line passing) to a non-default level, a timer starts that sets the output to its
default level when it expires. The timer resets when a valid I/O packet is received.
The Tn parameter defines the permissible amount of time to stay in a non-default (active) state. If Tn
= 0, Output Timeout is disabled (output levels are held indefinitely).
XBee/XBee-PRO S1 802.15.4 (Legacy) User Guide
I/O settings commands
76