Unfolding The 7550 Vt - Landoll VT Plus 7550 Operator's Manual

Unfolding the 7550 VT

Unfold in an area that is flat to allow the outer wing
fold plates to lock.
1. Disengage wing transport locks.
IMPORTANT
Failure to remove the lock pins
sure wing lock pin hole is aligned in front hole of lock
mount and the 3/8 x 1-1/2 lock pin is secured through
the aligned holes before unfolding or this will result
in serious damage to the implement. Be sure other
people and pets are a safe distance away read
2. Fully raise the folded machine to unhook the locks
and continue to hold the lever to fully extend the wing
transport wheels (See Figure 4-5.
Figure 4-6.).
CENTER LIFT TRANSPORT
LOCK ENGAGED
(See Figure 4-5.) be
and See
WING STABILIZER
Figure 4-6: Installed Transport Locks
OPERATION AND MAINTENANCE
3. Unfold the machine. Transport locks will disengage
from the center lifts during the unfolding process.
4. Continue to hold lever until the fold cylinders are fully
extended to lock the outer wing fold plates,
Figure 4-5.) This will allow the wings to fully flex in
the field.
NOTE
5. If the operator chooses to leave the wing
transport wheels extended while transporting the
VT, some settling of the machine may occur and
it will be necessary to raise the machine to
disengage the center lift transport locks.
(See
IMPORTANT: BE SURE
WING LOCK PIN HOLE
IS ALIGNED IN REAR
HOLE OF LOCK MOUNT
AND 3/8 X 1-1/2 LOCK
PIN IS SECRUED
THROUGH ALIGNED
HOLES IN FOLDED
TRANSPORT
POSTITION
4-7