Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Wing Frame Inner
1. Place the left and right inner wing frame assemblies
on stands so the wings are level with the center
frame
(See Figure
3-7.).
2.
Be sure the 1-3/4 flange bearings are in center
frame.Install 1-3/4 thrust washers on the front side of
both front and rear center frame hinges. Slide the
1-3/4 hinge pins through aligned holes in orientation
shown
(See Figure
washers over the threads before installing the 1-3/4-5
hex slotted nuts.
3. Secure the 1-3/4 hinge pin with 5/8 x 3 pin, 1-3/4-5
hex slotted nut and 3/8 x 2-1/2 slotted spring pin.
3-14
3-7.). Install the 1-3/4 thrust
4. Attach the tire/wheel assembly to all 8 bolt hub &
spindle assemblies with 5/8 wheel nut. Torque to 85
to 100 ft./lbs.
NOTE
All tire/wheel assemblies are installed with the valve
stem facing outward.
5. Attach the front gauge wheel assemblies to the wing
frames using1-8 x 6 hex bolts supplied with the
assembly, gauge wheel spacers, and 1-8 hex lock
nuts. Securely tighten the mounting screws to
eliminate any slack and unnecessary wear.
6. Install the 280/70R15 tire/wheel assemblies. Torque
to 85 to 100 ft-lbs.
F-987-0519
Advertisement
Chapters
Table of Contents
