Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Fold Assembly Center
The center fold should be installed after the gang
1. Attach the wing stabilizer front and rear, fold-stab
plates front and rear, doubler plates, base end of the
4-1/2 x 30 cylinders in orientation shown
Figures
3-6). Install the 4-1/2 x 30 cylinders on the
center frame with the front cylinder ports to the rear,
and the rear cylinders with ports facing forward.
3-12
DANGER
(See
2. Secure the base end of the 4-1/2 x 30 cylinders with
1-1/4 x 7 pin, 1-1/4 flat washers and 5/16 x 2-1/2
pins.
3. Secure the plates to the wing stabilizers and to the
center frame with 3/4-10 x 6 hex screws and 3/4-10
lock nuts in orientation show
4. Install 1-8 x 6-1/2 hex bolt through the plates from the
front and secure with 1-8 lock nut.
5. Attach the outer wing stop plates to outer holes of
the
wing stabilizer rear
and 3/4-10 lock nuts.
NOTE
Now the left side wing stabilizers and cylinders may
be installed the same way in orientation shown
Figures
3-6) pointing to the left side of machine.
(See Figures
3-6).
with
3/4-10 x 6 hex screws
(See
F-987-0519
Advertisement
Chapters
Table of Contents
