Folding The 7550 Vt - Landoll VT Plus 7550 Operator's Manual

OPERATION AND MAINTENANCE

Folding the 7550 VT

1. Fully raise the machine.
IMPORTANT
Be sure wing lock pin hole is aligned in front hole of
lock mount and the 3/8 x 1-1/2 lock pin is secured
through aligned holes before folding machine.
2. Begin folding the machine. Transport locks will
engage on the center lift as the outer wings are
folding, fully fold all inner and outer wings
Figure 4-5. and See Figure
CENTER LIFT TRANSPORT
LOCK DISENGAGED
4-6
(See
4-6.).
Figure 4-5: Stored Transport Locks
3. Take note that both center lift transport locks are
engaged. Lower machine to locks and continue to
hold lever, this will allow the inner and outer wing
transport wheels to retract, reducing the transport
width. It is not necessary to do this for transport if
operator chooses not to.
4. When the unit is fully folded, rotate and slide wing
lock pins rearward to engage wing lift transport locks
(See Figure 4-6.)
WING FOLD
PLATES
IMPORTANT: BE SURE
WING LOCK PIN HOLE IS
ALIGNED IN FRONT
HOLE OF LOCK MOUNT
AND 3/8 X 1-1/2 LOCK
PIN IS SECRUED
THROUGH ALIGNED
HOLES BEFORE
FOLDING WINGS
F-987-0519