Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Conditioner Reel Spring
Installation (Option)
NOTE
Refer to Conditioner Single Reel Installation shown in
Figure 3-24 for single reel installation or Conditioner
Double Reel Installation shown in Figure 3-25 for double
reel installation.
1. Slide the adjustment pin through the rear plates of
center and wing frames, secure with (2) 2-1/2 snap
rings.
2. Assemble the 1-8 x 9 adj bolt through adjustment pin
on frame, 1" lock washer, (2) 1-8 hex nuts, and 17"
heavy spring assembly.
3. Install 1-1/2" flange bearing into reel arm. Slide in
1-1/2" pivot bushing.
4. Attach reel arm to upper hole on rear center or wing
frame or double mount using 1-8 x 6-1/2 hex head
cap screw and hex lock nut.
3-30
5. Assemble 17" heavy spring assembly to reel arm
using 1" pivot pin, and 5/16 x 1-1/2" spring slotted
pins. Set pin centers to 21" dimension as shown in
Figure 3-24.
Do not attempt to lift heavy parts (such as the
frame, disc gangs, lift, pull hitch, or reel/gang bar
assembly manually. Use a hoist or a forklift to
move these parts into position.
6. Attach single reel/gang bar assembly to reel arms
using gang bar mount plate, 3/4-10 x 6 hex head cap
screws and double hex lock nuts as shown in Figure
3-24. Refer to pages 2-6 thru 2-17 for single reel
gang bar placement locations.
7. Attach double reel/gang bar assembly to reel arms
using gang bar mount plate, (2) clamp tubes, (4)
spring torsion rubber, secure with 3/4-10 x 8-1/2 hex
head cap screws and double hex lock nuts as shown
in Figure 3-25. Refer to pages 2-18 thru 2-23 for
double reel gang bar placement locations.
8. Install (2) clamp tubes on front and back of double
gang bar, secure with 1/2-13 x 5-1/2 hex cap screws
and 1-2 lock nuts. Refer to pages 2-18 thru 2-23 for
clamp tube locations. Each set (2 total) should be slid
against gangbar mount plate on outside of inner wing
arm assemblies.
WARNING
F-561-0818
Hide quick links:
Advertisement
Table of Contents
