Sending Switching Commands - HomeMatic HM-Sen-EP Installation And Operating Manual

• Press and hold down the operating button again
for around four seconds, until the status LED
lights up green. This signals that the sequence
has been deleted.
• The process can be aborted by briefly pressing the
operating button. After 20 seconds of inactivity,
the process will be aborted automatically and the
LED will go out.

8.4 Sending switching commands

The switching sequence that has been taught in,
plus a delay of at least 1 second, results in a switch-
ing command being transmitted for the relevant
channel. During this process, the status LED lights
up orange for as long as wireless transmission lasts.
When wireless transmission ends, the LED lights
up either red or green for 1 second, depending on
whether the process was successful.
To test whether the headlight flasher sensor is
transmitting commands, you can also send
switching commands for a channel by operating the
device directly. To do this, press the relevant
operating button (1 or 2).
58