HomeMatic HM-Sen-EP Installation And Operating Manual page 53

been executed can never be repeated with 100% ac-
curacy, a tolerance value of 50% is set automatically.
You can find more information about tolerance values
and changing default settings at the end of this sec-
tion. To set flashing sequences, proceed as follows:
• Press and hold down the operating button for
the required channel for around four seconds.
The status LED starts to light up green for 20
seconds. If a flashing sequence has already been
set for the required channel, the LED will light up
orange for 20 seconds.
• Perform the required flashing sequence by
activating the central locking mechanism or
headlight flasher.
• The status LED starts to light up orange for
around 20 seconds. The LED then goes out
automatically and the setting mode is exited.
• The process can be cancelled by briefly pressing
any button on the headlight flasher sensor.
When you repeat the flashing sequence you have
just set, the headlight flasher sensor sends a switch-
ing command. To ensure that minor differences that
occur when repeating the flashing sequence do
not stop the switching command from being sent,
a tolerance level has been set at the factory. This
53