HomeMatic HM-Sen-EP Installation And Operating Manual page 55

of entering the flashing sequence, until the status
LED lights up orange.
• Repeat this first flashing sequence once more.
The headlight flasher sensor stores the maximum
difference between the individual pulse and
pause lengths (in relation to the values stored
previously) as the new tolerance value. The mean
values based on the stored and repeated flashing
sequences are then stored as the new flashing
sequence.
• The status LED goes out if you wait four seconds
after the second time you enter the flashing
sequence.
• The process can be cancelled by briefly pressing
any button on the headlight flasher sensor.
The figure below illustrates this process in another way:
First procedure
Subsequent
procedure
Resulting values
Green
Orange
Difference
Tolerance Tolerance
55