Table of Contents
Advertisement
IPL T CR48 Interface Configuration
Configuring the IPL T CR48 using the ARP command
You can make use of the ARP command to set up an IP address for your IPL T CR48. The
ARP command tells your computer to associate the MAC address of the IPL T CR48 with
the assigned IP address. You must then use the ping command to access the IPL T CR48
unit, at which point the IP address of the device server is reconfigured.
NOTE: To use this setup method, both your computer and IPL T CR48 must be
connected to the same LAN. Or, you can use a crossover Ethernet cable to connect
the device server directly to the Ethernet card of the computer.
Use ARP to configure the IP address as follows:
1.
Obtain a valid IP address for your IPL T CR48 from your network administrator.
2.
Obtain the MAC address of the IPL T CR48 from the label on its back panel.
3.
If the unit has never been configured and is still set for factory defaults, go to step 4. If
not, perform a Mode 4 system reset (see
detailed information on reset modes).
NOTE: The IPL T CR48 unit must be configured with the factory default IP address:
192.168.254.254
following steps.
4.
On the PC, access the command prompt (from the Windows desktop), click
then
Run
5.
Type
Telnet
6.
Enter the desired new IP address for the IPL T CR48 and the MAC address (located on
the rear panel of the controller). For example:
arp -s 10.13.170.15 00-05-A6-00-0A-90
Figure 10.
7.
Execute a ping command by typing
at the command prompt. For example:
ping 10.13.170.15
After issuing this command, the unit changes to the new address and starts responding
to the ping requests, as shown below. You must ping the IPL T CR48 in order for the IP
address change to take place.
, before executing the ARP command, as described in the
.
in the
dialog box) then execute the arp -s command.
Run
Executing the ARP Command
Resetting the Controller
followed by a space and the new IP address
ping
IPL T CR48 • Connection and Configuration
on page 9 for
,
Start
13
Advertisement
Table of Contents
