Table of Contents
Advertisement
If the Image is Not Displayed Correctly
1.
If the output image looks too green, the
may be set to On (up), and the display device may not be configured to handle SOG
signals. Set the switch to Off (down).
2.
If the picture bends or flags at the top of the screen, set the
switch
3.
For a display device that experiences intermittent glitches, try changing the DDSP setting
using
4.
If the picture "hangs off" the edges of the screen, adjust the
(
[
,
{
5.
If the edges of the image seem to exceed their boundaries or if thin lines and sharp
edges look thick and fuzzy, try changing the
the image is too bright, decrease the boost or peaking level.
6.
If using the EDID Minder model, make sure the
(frequency) DIP switch
reboot the source device.
7.
If using the EDID Minder model, make sure the video output can support the resolution
provided by the EDID Minder. If necessary reset the
device.
8.
If the image still does not display correctly, call the Extron S3 Sales and Technical Support
Hotline (see the phone numbers listed on the back page of this guide).
If the Interface Does Not Respond to Controls
1.
If you cannot adjust the
may be in use. Ensure that
2.
If you cannot
[
(
knob) or vertical (
the interface via a remote control, the interface may be in front panel security lockout
(executive mode).
page 16).
If the Image is Not Correctly Centered
If the picture from a new source computer does not seem correctly centered, the input
position memory presets might require resetting. Reset the input position memories as
follows:
1.
Unplug the AC power cord from the interface.
2.
Hold the input selection switch up while you plug in the AC power cord to the interface
and wait approximately 5 seconds.
3.
Select the appropriate input
If Auto Switching Does Not Work
Auto switch works for RGBHV and RGBS video inputs only. Auto switch does not work for
RGsB video input.
NOTE:
(switch 3) to Off (down).
DIP switch
1.
).
are set to the correct values. If these settings are changed,
horizontal (
DIP switch 1
shift between inputs
{
knob) centering
Toggle executive mode off
and
The selection of RGsB video output on rear panel
auto switching.
sync on green (SOG) DIP switch
serration pulse DIP
centering controls
Level/Boost
Peak
or
rotary dial
and
rotary dial
[
knob) or vertical (
{
knob)
(DDSP) on the rear panel is Off (down).
(input selection switch) or
from the front panel, but you can operate
(see Front Panel Security Lockout on
adjust the horizontal and vertical
DIP switch 2
RGB 203 Rxi • Operation
(switch 2)
Control settings. If
two position
and reboot the source
centering, DDSP
adjust the horizontal
centering.
has no effect on
18
Advertisement
Table of Contents
