Table of Contents
Advertisement
Figure 11.
Unit Response to a Ping Request
You can reconnect using either Telnet or a web browser to verify that the update was
successful.
8.
After verifying that the change was successful, enter and issue the
the command prompt. For example:
arp -d 10.13.170.15
or
removes all static IP addresses from the arp table.
arp -d*
Configuring the IPL T CR48 using direct PC connection
This type of connection is used initially to connect to and configure the IPL T CR48. The
default settings of the unit (IP address, subnet mask, and [optional] administrator name and
password) must be changed in order to use the unit on an intranet (LAN) or on the Internet
(WAN).
NOTE: The factory configured passwords for all accounts on this device have been set
to the device serial number. In the event of a complete system reset, the passwords
convert to the default, which is no password (see
on page 19 to change a password).
1.
Plug one end of a CAT 5 crossover Ethernet cable into the rear panel Ethernet
connector on the IPL T CR48 (see
2.
Plug the other end of the Ethernet cable into the Ethernet port on your PC.
3.
Right-click on the
Network Neighborhood
Windows (98, 2000, NT, ME, XP) desktop and select
4.
Select
Internet Protocol (TCP/IP)
or
If you are using Windows 2000:
1.
Right-click
Local Area Connection
2.
Select
Internet Protocol (TCP/IP)
3.
Click on
Properties
If
Internet Protocol (TCP/IP)
to your Windows user guide or the online Help system for information on how to install
the TCP/IP protocol.
removes 10.13.170.15 from the arp table
Setting and changing passwords
figure 7
on page 7 for RJ-45 connector wiring).
or
My Network Places
from the list and click on
and select
) from the list.
.
) is not on the list, it must be added (installed). Refer
IPL T CR48 • Connection and Configuration
command at
arp -d
icon on your
from the menu.
Properties
.
Properties
from the menu.
Properties
14
Advertisement
Table of Contents
