Installation And Configuration; Installation Steps - Extron electronics Quantum Ultra Series User Manual

Installation and
Configuration
This section provides the steps to install the Quantum Ultra Series processor. It also
describes the rear panel components and provides instructions for cabling.
•
•
•
•
•
•
•
•

Installation Steps

The Quantum Ultra Series processor can be mounted in a 19-inch equipment rack or
placed on furniture. To install and set up the processor for a videowall, follow the steps
below (see
NOTE: To install a Quantum Ultra Series expansion system, see
1.
2.
3.
4.
5.
Quantum Ultra Series Videowall Processing Systems • Installation and Configuration
Installation Steps
Front Panel Features
Rear Panel Features
Input and Output Cards
Adjusting for Edge Blending and Mullion Compensation
Connecting to a Network
RS-232 Insertion - DTP Outputs Only
Expansion Cards
Application Examples
Expansion Cards on page 48.
Disconnect power from the processor and all other equipment in the system.
If desired, rack mount the unit (see
page 114).
Connect HDMI sources and LAN connections to the installed input cards.
Connect HDMI displays, DTP or HDBaseT receivers, or an XTP matrix switcher to the
connectors on the installed output cards as appropriate.
Secure each HDMI connector with a provided LockIt bracket (see
Cable Lacing Brackets on page 19).
NOTE: With an adapters DVI is available on any HDMI port.
Connect a control device or computer for remote control to:
a.
The rear panel RJ-45 LAN A or LAN B jack to enable configuration and control of
the processor via Simple Instruction Set (SIS) commands (see
starting on page 62) or VCS (LAN A recommended) (see the VCS Help File), or
for streaming a VNC source (LAN B recommended).
b. (Optional) The rear panel USB mini-B Config connector to enable control via VCS
or SIS commands.
c. (Optional) The rear panel 3-pole captive screw RS-232 connector to enable serial
control via SIS commands.
starting on page 9).
Mounting the Quantum Ultra Series
Connecting the
on
HDMI LockIt
SIS Commands
13