Specifications - Sony STR-DN1010 Operating Instructions Manual

For other messages, see "Message list after
Auto Calibration measurement" (page 43),
"DIGITAL MEDIA PORT message list"
(page 51) and "SIRIUS Satellite Radio
message list" (page 64).
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver's memory may remedy
the problem (page 37). However, note that all
memorized settings will be reset to their initial
settings and you will have to readjust all
settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
In the event of a problem with S-AIR function,
have a Sony dealer check the entire system
together (S-AIR main unit and S-AIR sub
unit).
Reference sections for clearing
the receiver's memory
To clear
All memorized settings
Customized sound fields

Specifications

AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(Models of area code U2 only)
With 8 ohm loads, both channels driven, from
20
channel minimum RMS power, with no more
than 0.09% total harmonic distortion from
250 milliwatts to rated output.
Amplifier section
Models of area code U2
Minimum RMS Output Power
(8 ohms, 20 Hz – 20 kHz, THD 0.09%)
Stereo Mode Output Power
(8 ohms, 1 kHz, THD 1%)
Surround Mode Output Power
(8 ohms, 1 kHz, THD 10%)
Models of area code CA2
Minimum RMS Output Power
(8 ohms, 20 Hz – 20 kHz, THD 0.09%)
Stereo Mode Output Power
(8 ohms, 1 kHz, THD 1%)
See
page 37
Surround Mode Output Power
page 69
(8 ohms, 1 kHz, THD 10%)
Models of area code CEK, ECE, AU1, TW2
Stereo Mode Output Power
(8 ohms, 1 kHz, THD 1%)
Surround Mode Output Power
(8 ohms, 1 kHz, THD 10%)
– 20,000 Hz; rated 100 watts per
Hz
1)
100 W + 100 W
110 W + 110 W
150 W per channel
1)
95 W + 95 W
110 W + 110 W
150 W per channel
100 W + 100 W
140 W per channel
2)
2)
1)
2)
continued
GB
129