Sony STR-DN1010 Operating Instructions Manual page 15

wg
wf
wd
ws
wa
w;
ql
qk
qj
qh
qg
qf
qd
Name and function
A
?/1 (on/standby)
Turns the receiver on or sets it to the standby
1
mode.
2
To turn off all components, press ?/1 and
AV ?/1 (B) at the same time (SYSTEM
3
STANDBY).
Saving the power in standby mode
When "Ctrl for HDMI" is set to "OFF" (page
70) and "S-AIR Stby" is set to "OFF" (page 83).
4
B
AV ?/1
Turns on or off the audio/video components that
the remote is programmed to operate.
To turn the TV on or off, press TV (W) and
then press AV ?/1.
If you press ?/1 (A) at the same time, it will
turn off the receiver and other components
5
(SYSTEM STANDBY).
Note
6
The function of the AV ?/1 switch changes
automatically each time you press the input
7
buttons (D).
C AMP
The button lights up and activates the receiver
operation (page 101).
D Input buttons (VIDEO 1
8
Selects the component you want to use. When
9
you press any of the input buttons, the receiver
turns on. The buttons are initial assigned to
control Sony components. You can program the
remote to control non-Sony components
0 following the steps in "Programming the
remote" on page 112.
Numeric buttons
Press SHIFT (V), then press numeric buttons
to
– preset/tune to preset stations.
qa
– select track numbers. Press 0/10 to select track
number 10.
– select channel numbers.
qs
Press TV (W), then press the numeric buttons
to select the TV channels.
a)
-/--
Press SHIFT (V), then press -/-- to select the
channel entry mode, either one or two digit.
To select the channel entry mode of the TV,
press TV (W) and then press -/--.
a)
>10
Press SHIFT (V), then press >10 to select track
numbers over 10. You can also select the
channel numbers of the DIGITAL CATV
terminal.
a)
(on/standby)
b)
)
a)
(number 5
continued
.
b)
)
GB
15