Sony VENICE MPC-3610 Operating Instructions Manual page 9

000 9
1. Overview: Location and Function of Parts
SxS memory card slot block (page 24)
The SxS memory card slots are located behind the
cover.
1.
SxS memory card slots A/B
2.
Manufacturer calibration terminal
Manufacturer terminal for calibration and
servicing (cannot be used by users).
3.
SLOT SELECT (SxS memory card select)
button
Press to switch the active slot.
Assistant Side
1 2 3
1
2
18
17
3
1.
ASSIGN (assignable) button 4 (page 39)
Assign functions using the EDIT page of the
user functions screen (page 39).
The assigned function toggles between on/off
(enable/disable) or is activated with each
press.
2.
ASSIGN (assignable) lamp 4 (page 39)
The lamp is lit orange when the assigned
function is on (enabled) or activated, and not
lit when the function is off (disabled).
3.
Sub display
Allows you to check the operation status of
the unit and make various settings
(page 31).
4
1 2 3
4 5 6
16 14 12
15 13 11 10
With the Home screen displayed, press and
hold the BACK button (page 10) and turn
the SEL/SET dial to adjust the brightness of the
sub display and mini display.
The brightness can also be adjusted using
Technical > Control Display > Brightness level
(page 70) in the full menu.
4.
Sub display ITEM keys 1 to 6
Controls the operation of functions on the sub
display (page 43).
5.
Tape measure hook
The tape measure hook is on the same plane
as the image sensor. To measure the precise
distance between the unit and the subject, use
the tape measure hook as a reference. You can
attach the end of a tape measure to the hook,
and measure the distance from the subject.
6.
HOME button
Press to clear the display and return to the
Home screen on the sub display (page 33).
If pressed when the unit is in playback state,
the unit transitions to shooting mode.
5
7.
MENU (menu display on/off) button (pages
43, 54)
Press the MENU button to display the menu
screen on the sub display. Press and hold the
6
MENU button for 2 seconds or longer to
display the full menu screen on the sub
display. Press the button during menu screen
7
or full menu screen display to return to the
previous screen display.
8.
SEL/SET (select/set) dial (MENU dial)
8
Changes the item selection or a setting within
the menu (pages 33, 43, 54).
9.
+48V power lamp
9
Lights in green if the AUDIO IN switch is set to
MIC and +48 V phantom power is supplied on
the AUDIO IN connector. It is not lit if phantom
power is not supplied.
You can turn +48 V phantom power on/off
using Audio category > Audio Details > Audio
Configuration > Phantom Power +48V
(page 67) in the menu.
10.
AUDIO IN (audio selector) switch
Select the input signal type corresponding to
the audio source connected to the AUDIO IN
connector.
LINE: When connecting an external analog
audio signal source
AES/EBU: When connecting an external digital
audio signal source
MIC: When connecting a microphone