Sony VENICE MPC-3610 Operating Instructions Manual page 80

000 80
4. Network: Network Setup and Operations
4
Insert the CBK-WA02 into the USB connector of
the USB extension adaptor.
Connecting in access point mode
The unit can connect to devices that are set up as
an access point.
Computer
Smartphone/
Tablet
Connecting using WPS-equipped devices
Devices that support WPS can be connected using
WPS.
1
Set Technical > Network > Setting (page 69)
in the full menu to Wireless.
2
Set Technical > Network > Wireless > Network
Mode (page 69) in the full menu to Access
Point.
3
Select Technical > Network > Wireless > WPS
(page 69) in the full menu.
4
Select Execute by turning the MENU dial, then
press the MENU dial.
5
Open the device Network Settings or Wi-Fi
Settings, and turn Wi-Fi on.
6
Press the WPS push button in the device
Network Settings or Wi-Fi Settings preferences.
[Note]
The steps will vary depending on the device used.
Connecting using SSID and password on the device
Connect by entering the SSID and password on
the device.
1
Set Technical > Network > Setting (page 69)
in the full menu to Wireless.
2
Set Technical > Network > Wireless > Network
Mode (page 69) in the full menu to Access
Point.
3
Open the device Network Settings or Wi-Fi
Settings, and turn Wi-Fi on.
4
Select the unit's SSID from the Wi-Fi network
SSID list, then enter a password to connect.
For the unit's SSID and password, see Technical
> Network > Wireless > SSID and Password
(page 69) in the full menu.
[Note]
The steps will vary depending on the device used.
Connecting in station mode
The unit can connect to existing wireless LAN
access points as a client.
The device connects via the access point.
Computer
Smartphone/
Tablet
Access
point
Connecting to an access point using WPS
If an access point supports the WPS function, you
can connect using a basic setting.
1
Turn the access point on.
2
Turn the unit on.
3
Set Technical > Network > Setting (page 69)
in the full menu to Wireless.
4
Set Technical > Network > Wireless > Network
Mode (page 69) in the full menu to Station.
5
Select Technical > Network > Wireless > WPS
(page 69) in the full menu.
6
Select Execute by turning the MENU dial, then
press the MENU dial.
7
Press the access point WPS button.
For details about WPS button operation, refer
to the instruction manual for the access point.
[Note]
If the connection fails, perform the procedure again from
1
step .
Connecting by entering a SSID and password
Connect by entering the SSID and password on
the unit.
1
Set Technical > Network > Setting (page 69)
in the full menu to Wireless.
2
Set Technical > Network > Wireless > Network
Mode (page 69) in the full menu to Station.
3
Set the following items in Technical > Network
> Wireless (page 69) in the full menu.
ˎ SSID ˎ
ˎ Password ˎ
ˎ DHCP ˎ
ˎ IP Address ˎ
ˎ Subnet Mask ˎ
4
Select Set to confirm.
[Note]
Always use Set to confirm the settings. If the settings are not
confirmed using Set, the configured settings are not applied.