Sony VENICE MPC-3610 Operating Instructions Manual page 69

000 69
3. Camera Operations: Full Menu List
Technical > Lens Configuration
Makes settings related to lenses.
Menu item Settings
Lens 12pin On/Off
E-Mount Shading Auto/Off
Comp.
E-Mt Chro. Aber. Comp. Auto/Off
Technical > Authentication
Makes basic settings related to network authentication.
Menu item Settings
User Name (Displays the current user name.) Sets the user name to use for access
Password (*******)
Technical > Network
Makes settings related to the network.
Menu item Settings
Setting LAN/Wireless/Off
LAN DHCP (On/Off)
IP Address (DHCP/On:
automatically, DHCP/Off:
192.168.2.50)
Subnet Mask (DHCP/On:
automatically, DHCP/Off:
255.255.255.0)
Description
Turns the 12-pin lens interface on/off.
[Note]
If changing this setting while the lens is attached to the
unit, turn the turn off and then on again.
Sets whether to compensate for a drop in
peripheral lighting when a compatible lens is
attached.
Sets whether to compensate for chromatic
aberration in peripheral lighting when a
compatible lens is attached.
Description
authentication.
Set to "admin" by factory default.
Sets the password to use for access
authentication.
Set to "mpc3610" by factory default.
Description
Turns the network connection on/off.
Enables/disables DHCP.
When set to [On], an IP address is automatically
assigned to the unit. To enter the IP address of the
unit manually, set to [Off].
obtain Enter the IP address of the unit.
Enabled only when DHCP is [Off].
obtain Enter the subnet mask of the unit.
Enabled only when DHCP is [Off].
Technical > Network
Makes settings related to the network.
Menu item Settings
Wireless Network Mode (Access
Station)
Scan Networks (Execute/Cancel)
SSID
Password
WPS (Execute/Cancel)
Channel (Auto(5GHz)/Auto/CH1/
CH2/CH3/CH4/CH5/CH6/CH7/
CH8/CH9/CH10/CH11)
Description
Point/ Sets the network mode for wireless connections.
Scans for access points for connection
destinations (execute by selecting Execute).
[Note]
Configurable only when Network Mode is set to Station.
When Network Mode is set to Access Point
Displays the SSID for the wireless connection
to the unit.
When Network Mode is set to Station
Displays/configures the SSID of the
connection destination access point.
[Note]
Valid characters for display and entry:
Alphabetic (A to Z, a to z)
Numeric (0 to 9 -.@—_())
Symbols (!"#$%&'*+,/:;<=>?[\]^`{|}~)
When Network Mode is set to Access Point
Displays the password for wireless connection
to the unit.
When Network Mode is set to Station
Displays/configures the password of the
connection destination access point.
[Note]
Valid characters for display and entry:
Alphabetic (A to Z, a to z)
Numeric (0 to 9 -.@—_())
Symbols (!"#$%&'*+,/:;<=>?[\]^`{|}~)
Starts connection setup using WPS (execute by
selecting Execute).
Sets the channel of the access point.
[Notes]
ˎ Configurable only when Network Mode is set to
ˎ
Access Point.
ˎ Auto(5GHz) may not be displayed, depending on ˎ
the wireless LAN module being used. Check whether
use of the wireless LAN module is supported in your
country/region. For details, refer to the operating
instructions of the wireless LAN module.