Preparation For Operation - ODB LCT6000 Owner's Manual

ODB COMPANY
Pre-Operating Section

2.3 Preparation For Operation

Before your leaf vacuum is put into operation it is very important to read and fol-
low the procedures outlined in the engine owner's manual. (EOM).
For specific information regarding the following checks please refer to the
"Maintenance" section of this manual and the engine owner's manual.
DISENGAGE the clutch and remove the negative battery cable before performing
the following checks.
NEVER place any part of the body under or behind guards or any other area in
which you cannot see.
IMPORTANT CHECKS:
NOTE: The following checks contained in the next three sections should be
performed prior to leaving the storage area.
1. Check engine fuel, coolant and oil levels. (see EOM)
2. Check engine air filter
3. Check all bolts and nuts to ensure they are tight.
4. Check all controls for free and proper operation.
5. Check main drive belt (if equipped) for proper adjustment.
6. Inspect the fan blades to ensure that they are not bent , deformed, fa-
tiqued or cracked. Replace fan if any damage is present.
7. Inspect the intake hose flange to make sure it is connected correctly to the
blower housing.
8. Inspect the leaf vacuum frame and structure for any bent, broken, cracked,
missing or loose parts.
9. Check all guards to ensure they are undamaged, in place and properly
secured.
10. All decals must be in place and legible prior to operating the leaf vacuum.
See the decal section for decal replacement.
800-446-9823
23
LCT6000