Split Setting - RGBlink VENUS X1 Manual

3.7 Split Setting

SPLIT is used when multiple VENUS X1 are used in cascade mode. When do cascade, connect the
signals to the signal distributor first, then connect from the outputs of the signal distributor to
each input of VENUS X1. User can also do cascade via DVI LOOP port, and it needs to select "DVI
LOOP" for <DVI1 OUTPUT> in menus.
The operations are as follows:
Push the [SPLIT] button, the button LED light will turn on, and enter the split function menus.
Turn the knob to select the split mode, there are two split modes, fixed split and normal split, the
OLED module show as follows:
FIXED SPLIT: Menus are as follows:
SPLIT: Split function, can select "ON" or "OFF", default "OFF".
HORIZONTAL SPLIT: Horizontal fixed split, select it and push the number button to set the total
horizontal screen number.
VERTICAL SPLIT: Vertical fixed split, select it and push the number button to set the total vertical
screen number.
SPLIT INDEX: Use can select the split index, and the LED screen will show the corresponding
image.
H SIZE: The width of the device when do split.
V SIZE: The height of the device when do split.
ADVANCE: H SIZE, V SIZE, H POS and V POS setting. If image quality distorts by improper
operation, it can be recover by reset.
NORMAL SPLIT: For normal split, user should enable the split function, that is, turn the knob, and
set the <SPLIT> as "ON", push the knob to confirm. System default "OFF". User can set the
normal split in the sub menus:
->FIXED SPLIT
NORMAL SPLIT
->SPLIT
HORIZONTAL SPLIT
VERTICAL SPLIT
SPLIT INDEX
->H SIZE
V SIZE
ADVANCE
37
>>
>>
OFF
1
1
1
1920
1080
>>