Split Setting - RGBlink GX4 Quick Start Manual

Hide thumbs Also See for GX4:

Table of Contents

Select:

Select image A or image B. For example, select image B, the settings will be available for image B.

Swap Window:

Enable or disable the swap window function.

Alpha:

Image transparency setting, the adjustment range is 0 to 16.

Split Setting

SPLIT is used when multiple GX4 are used in cascade mode. When do cascade, connect the signals to the signal

distributor first, and then connect from the outputs of the signal distributor to each input of GX4. User can also

do cascade via DVI LOOP port, and it needs to select "DVI LOOP" for <DVI1 OUTPUT> in menus. The operations

are as follows:

Push the [SPLIT] button, the button LED light will turn on, and enter to the split function menus. Turn the knob

to select the split mode, there are two split modes, fixed split and normal split.

FIXED SPLIT: Menus are as follows:

SPLIT: Split function, can choose "ON" or "OFF". System default "OFF".

HORIZONTAL SPLIT: Horizontal fixed split, select it and push the number button to set the total horizontal screen

number.

VERTICAL SPLIT: Vertical fixed split, choose it and push the number button to set the total vertical screen

number.

SPLIT INDEX: Use can select the split index, and the LED screen will show the corresponding image.

H SIZE: The width of the device when do split.

V SIZE: The height of the device when do split.

ADVANCE: H SIZE, V SIZE, H POS and V POS setting. If image quality distorts by improper operation, it can be

recover by reset.

NORMAL SPLIT: For normal split, user should enable the split function, that is, turn the knob, and set the

<SPLIT> as "ON", push the knob to confirm. System default "OFF". User can set the normal split in the sub

menus:

H TOTAL: LED screen Horizontal total size.

9 / 20

Ph: +86 592 5771197 |

support@rgblink.com

www.rgblink.com

Table of Contents