Siemens SENTRON PAC4200 Manual page 95

Parameterizing
7.2 Parameterizing via the user interface
Voltage dip/swell
Selection
NOM. VOLTAGE
VOLTAGE DIP
VOLTAGE DIP
HYSTERESIS
VOLTAGE SWELL
VOLTAGE SWELL
HYSTERESIS
VOLTAGE INTERRUPTION
VOLTAGE INTERRUPTION
HYSTERESIS
Nominal frequency
Selection
NOM. FREQUENCY
94
Range
Specification of nominal voltage Udin according to IEC 61000-4-30. The
specification refers to the L-N measuring voltage. In 3-wire systems, the
specification refers to the L-L measuring voltage.
0 V ... 999999 V
Specification of dip threshold referred to NOM.VOLTAGE value. When
the measured value falls below the threshold, evaluation of the voltage
dip is initiated.
0.0% ... 100%
Specification of hysteresis referred to NOM.VOLTAGE value. When the
measured value falls below or rises above the VOLTAGE DIP threshold
plus HYSTERESIS, evaluation of the voltage dip is started or ended.
0.0% ... 5%
Specification of swell threshold referred to NOM.VOLTAGE value. When
the measured value rises above the threshold, evaluation of the voltage
swell is initiated.
100.0% ... 120%
Specification of hysteresis referred to NOM.VOLTAGE value. When the
measured value rises above or falls below the VOLTAGE DIP threshold
plus HYSTERESIS, evaluation of the voltage swell is started or ended.
0.0% ... 5%
Specification of threshold for a voltage interruption referred to
NOM.VOLTAGE value. When the measured value rises above or falls
below the threshold, evaluation of the voltage swell is initiated or ended.
0.0% ... 100%
Specification of hysteresis referred to NOM.VOLTAGE value. When the
measured value rises above or falls below the VOLTAGE
INTERRUPTION threshold plus HYSTERESIS, evaluation of the voltage
swell is started or ended.
0.0% ... 5%
Range
Input of line frequency in Hz
AUTO
•
50 Hz
•
60 Hz
•
Factory setting
230 V
90%
2%
110%
2%
10%
2%
Factory setting
AUTO
System Manual, 05/2019, A5E02316180B-05
PAC4200