Siemens SENTRON PAC4200 Manual page 84

Table 6- 2 The following events are reported:
Event Event
class
START PMD System
information
PMD INFO System
information
COMM.FAULT System
information
FW UPDATE # System
information
TIME CORR: System information
TIME SYNC # System information
VOLTAGE # Operating infor-
mation
Operating infor-
VOLTAGE
mation
Operating infor-
CURRENT
mation
Operating infor-
LIM
mation
Operating infor-
LIM
mation
PAC4200
System Manual, 05/2019, A5E02316180B-05
Standard Reason
warning level
Information Voltage recovery
Warning PMD information
Warning A communications fault has
occurred at the slot xx interface.
Warning Transmission error:
The firmware is not suitable.
Information Top of minute:
The time has been corrected.
Information The time synchronization has
failed.
Interface: Slot xx
Warning The supply voltage has been
interrupted.
Measured variable x
Alarm The voltage is out of range.
Measured variable x
Alarm The current is out of range.
Measured variable x
Information The upper limit value xxxx has
been exceeded.
Measured variable x, limit val-
ue xxxx
Information The lower limit value xxxx has
been exceeded.
Measured variable x, limit val-
ue xxxx
Operation
6.2 Special displays
Remedy
-
Please contact Support.
Check the network set-
tings
Make sure you are using
the correct firmware
version for the update.
Restart the firmware
update.
-
The "Top of minute"
pulses for synchronizing
the time are not active.
Check the hardware and
the settings for transmit-
ting the "Top of minute"
pulses.
The device has been
disconnected from the
network in accordance
with the schedule.
An error has occurred.
Check the power supply.
Danger of serious or
fatal injury or of serious
damage to the device.
Make sure the system is
operating under condi-
tions for which
SENTRON PAC4200 is
approved.
It is possible that the
measured values are not
correctly displayed.
Please contact Support.
-
-
83