Siemens SENTRON PAC4200 Manual page 85

Operation
6.2 Special displays
Event Event
class
LIMIT LOG. OP=1 Operating infor-
mation
TARIFF Operating infor-
mation
STATUS DI Operating infor-
mation
STATUS DO Operating infor-
mation
Operating infor-
PULSE FREQ
mation
TIME Operating infor-
mation
FACT. DEFAULTS Operating infor-
mation
VOLTAGE Operating infor-
INTERRUPT mation
VOLTAGE SWELL Operating infor-
mation
VOLTAGE DIP/SAG Operating infor-
mation
BASIC PARAM Operation
SETTING Operation
COMM. Operation
MAX/MIN=0 Operation
84
Standard Reason
warning level
Information The limit logic operation com-
plies with the limit value xxxx.
Information Tariff change to ...
Information The digital input is activated.
DI address xx.xx
Information The digital output is activated.
DO address xx.xx
Information The pulse frequency is too high.
DO address xx.xx
Information The time was set on:
Slot xx interface
Information The factory defaults have been
set.
Slot xx interface
Information Voltage interruption referred to
nom. voltage value
Duration in seconds
•
Residual voltage in volts
•
Affected phase
•
Information Swell in measuring voltage,
referred to nominal voltage value
Duration in seconds
•
Residual voltage in volts
•
Affected phase
•
Information Swell in measuring voltage,
referred to nominal voltage value
Duration in seconds
•
Residual voltage in volts
•
Affected phase
•
Warning The basic configuration has
been changed.
Slot xx interface
Warning The configuration has been
changed.
Slot xx interface
Information The communication configura-
tion has been changed.
Slot xx interface
Information The maximum/minimum values
were reset.
Slot xx interface
Remedy
System Manual, 05/2019, A5E02316180B-05
-
-
-
-
-
-
-
-
-
-
-
-
-
-
PAC4200