Patlite WD PRO Series Instruction Manual page 61

Wireless Data Communication System - WD PRO Series Instruction Manual
●External Interface
Item
Power Supply Wire
Signal Wire
Contact Input
Line
Flashing Common Line
External Input Common Line
RS-232C
Communication method
USB
* 1 Input Reaction Time: 100 ms or longer, Signal Wire Current: 6 mA or less
* 2 Use only for maintenance. ☞ 5.2.2.2 WD System Configuration at Maintenance(P.14)
UL1061 AWG24 x 2 (24 VDC, GND)
UL1061 AWG24 x 17
Signal Tower Control
6 contacts (external relay/NPN/PNP) *
Line
External Input Line 8 contacts (external relay/NPN/PNP) *
Clear Input Line 1 contacts (external relay/NPN/PNP) *
1 contact (60±2/minute)
1 contact
Screwless terminal block (6 contacts) supported lead wire: AWG24 to 28
(stranded wire)
・Transmission method: Full duplex
・Synchronization method: Asynchronous
・Baud rate: 4800/9600/19200/38400/57600/115200 bps
・Data length: 7 bits/8 bits
・Parity: None/Even/Odd
・Stop Bit: 1 bit / 2 bits
・Maximum cable length possible for connection: 15 m
micro-USB connector (B terminal)*
Description
2
61
10. Specifications
1
1
1