Attaching The Led Unit And Buzzer Unit - Patlite WD PRO Series Instruction Manual

Wireless Data Communication System - WD PRO Series Instruction Manual

7.2.1.2 Attaching the LED Unit and Buzzer Unit

Attach or detach units one at a time.
Install one unit at
a time
If WDT-PRO does not attach properly to WDB-D80S, confirm the tab of
the cylinder-shaped part at the top of WDT-PRO is fitted correctly into
the groove. If the tab is outside the groove as shown in the figure (right),
refer to the figure below on how to reposition it. Additionally, depending
on how it is detached, the tab may come out of the groove as shown
in the figure (right) when detaching the WDT-PRO from WDB-D80S.
Attaching while the tab is still in this state may cause damage.
●If WDT-PRO does not attach properly to WDB-D80S, turn the cylinder-shaped part in the middle of the bottom surface
counterclockwise. Next, turn the cylinder-shaped part until it snaps into place, then attach it to WDB-D80S.
Nameplate
Cylinder-shaped Part
CAUTION
Buzzer Unit
Buzzer Unit
LED Unit
LED Unit
WDT-PRO
WDT-PRO
WDB-D80S WDB-D80S
NOTICE
Cylinder-shaped Part
Nameplate
Top View
(Attachable)
Install one unit at
a time
Nameplate
Cannot Connect Condition
Tab and Groove
Tab and Groove
37
7. Operation
Tab
Cylinder-shaped Part
Groove
Tab
Tab
Groove
Groove
Top View
Cylinder-shaped Part
Nameplate
Cylinder-shaped Part
Bottom View