Wdt-6Lr-Z2-Pro (Wd Pro Transmitter) - Patlite WD PRO Series Instruction Manual

Wireless Data Communication System - WD PRO Series Instruction Manual

9.1.2 WDT-6LR-Z2-PRO (WD PRO Transmitter)

Issue
Indicator does not light up.
The indicator is flashing red.
(not pulsing)
The indicator is flashing amber.
(not pulsing)
The indicator does not change from a red light to a
red pulse.
The indicator flashes blue.
The indicator flashes alternating between green and
red.
The indicator light is purple.
The host cannot determine if the WDT is available.
Cannot get the buzzer input information.
Counter value is not increasing.
Cannot get RS-232C communication data.
・Check if it is installed correctly.
・Check if WDB-D80S wiring for the power supply is correct.
WDB-D80S DIP switches may be set up incorrectly. For normal
operation, turn off all DIP switches then turn the power back on.
If it continues to flash red, it may be an indication that the WDT-PRO
settings are corrupted. Initialize the product and set up again.
If it continues to flash red, it may be an indication that the WDT-PRO
may have failed. Please contact your local sales representative.
WDB-D80S DIP switches may be set up incorrectly. For normal
operation, turn off all DIP switches then turn the power back on.
If it continues to flash amber, it may be an indication that the WDB-80S
settings are corrupted. Initialize the product and set up again.
If it continues to flash amber, it may be an indication that the WDB-
D80S may have failed. Please contact your local sales representative.
Wireless connection with WDR is in progress.
・Depending on the radio wave environment, it may take some time
to complete the connection. Check the indicator again after about
5 minutes.
・Check if the WDR is working properly.
・The ExtendedPanID in the WDR must match the wireless channel
setting for a connection. Make sure the settings are correct.
・Check for any sources of noise (such as microwave ovens) in the
surrounding area that could impede wireless communication.
When the host transmits a call out command to the WDT, the indicator
flashes blue for about 10 seconds.
Starting up in initialization mode. If operations are normal, set the
WDB-D80S DIP switch 1 to [OFF].
Running in mode that is not normal. For normal operation, turn off all
WDB-D80S-PRO DIP switches.
If a wireless connection cannot be completed, the host cannot check
if the WDT is available. Check if the indicator on the target WDT is
pulsing, to indicate connection is complete.
Cannot get buzzer input information with [Standard Format] when the
Input Information Transmission Format is [WDT-LR Format]. Either
use [Extended Format] or change the Input Information Transmission
Format to [WDT-PRO Format].
In WDS-WIN01, select the Signal Tower control line for the simple
counter.
Make sure the communication settings and receive data file format
settings are correct. To check if WDT-PRO is transmitting RS-
232C communication data, see if the indicator light changes light
blue→flashing light blue. If it does not flash light blue, RS-232C
communication data is not being transmitted to the host. Check if the
WDT-PRO and WDR have a wireless connection. If you still cannot get
RS-232C communication data, make sure the communication settings
and receive data file format settings are correct.
59
9. Troubleshooting
Checklist