Remote Control Functions - Patlite WD PRO Series Instruction Manual

Wireless Data Communication System - WD PRO Series Instruction Manual

8.1.2 Remote Control Functions

Remote Control Functions*
Control is possible when receiving specific commands from the host. These functions operate with a higher priority
than Signal Tower Control Functions.
Based on the control
instruction, change to
the specified color and
buzzer status
Signal Tower
Control Line
LED unit control
Buzzer unit control
Control Status Response
* 1 Triple flash does not work on LR6-E-MZ.
* 2 Cannot use with WDS-WIN01.
* 3 When using continuous buzzer to control the buzzer unit, set the buzzer pattern to [Continuous beep].
●The operation status of LED and buzzer units, controlled with remote control functions from the host, is not transmitted
back to the host as Signal Tower information as the control is not carried out by Signal Tower control inputs.
●While LED and buzzer units are controlled with remote control functions from the host, and inputs change on the Signal
Tower control line, that Signal Tower information is transmitted to the host.
2
uses specific commands from the host to perform remote control of LED or buzzer units.
WDB-D80S \
WDT-PRO
Control the following states individually for each color.
Light on/Flashing/Light off/Triple flash*
Buzzer on/Continuous*
When a specific command is received from the host, response command that includes the
status of the LED unit or buzzer unit that is under remote control.
Control Instruction
・Control on/off
・Status of each color+buzzer
1
/control from Signal Tower control line
3
/Buzzer off/control from Signal Tower control line
NOTICE
46
8. Function Details
Host PC