When Not Using The Rs-232C Cable - Patlite WD PRO Series Instruction Manual

Wireless Data Communication System - WD PRO Series Instruction Manual

7.1.1.3 When Not Using the RS-232C Cable

❶
In the mounting location, drill holes for mounting
and wiring the product.
☞ Mounting Hole Dimension Diagram(P.25)
* When using a pole bracket and pole, drilling holes is
unnecessary.
❷
Rotate the body counterclockwise and detach
from the direct mount bracket.
❸
Apply the sealing plug and cap to the cable
gland, and rotate the cap clockwise to attach.
* When the sealing plug pops out of the cap, use your hand
to push the sealing plug back in.
Recommended Torque
0.6 N•m (approximate)
❹
Use nuts to secure the direct mount bracket in
the mounting position.
Recommended Torque
0.6 N•m (approximate)
☞ 7.1.2 Replacing Mounting Bolts (M4 → M3) on the
Main Unit(P.31)
* Do not secure when using a pole bracket and pole.
❺
Pass the wires (gray or black) through the wire
distribution hole.
* When using a pole bracket and pole, refer to "7.1.1.4
Wiring Method When Using Pole Bracket and Pole
(Accessories)( P.30)".
❻
Attach the body to the direct mount bracket,
reversing the steps for detaching.
❼
If required, apply sealant around the mounting
and wire distribution holes.
Body
❷
Direct Mount
Bracket
❺
❹
* This illustration presents an overview of installation and
does not reflect the installation status at each step.
29
7. Operation
❻
Cable gland
❸
Sealing plug
(accessory)
Cap
(accessory) ❶❼
*Maximum board
thickness: 7 mm