Table of Contents
Advertisement
Wireless Data Communication System - WD PRO Series Instruction Manual
7. Operation
7.1 WDB-D80S Installation
7.1.1 Installing and Removing WDB-D80S
●Requirements for the mounting location.
・ Minimal vibration・Strong・Level
●Install this product in the upright position.
●If you need to install on an uneven surface and waterproofing is required, use a sealant in the gap between the product
and mounting surface.
●For IP65 rating requirement, when clamping brackets to the mounting surface, apply sealant to the screw or nut portion
and the wire distribution hole.
●When using the RS-232C cable, fix it in place so it is not subjected to bending or pulling.
About the RS-232C Cable
・There are two wiring methods for the RS-232C cable, "Wiring RS-232C Cable from Bottom of Main Unit" and
"Wiring RS-232C Cable from Cable Gland".
・The RS-232C cable is offered as an accessory (Part number WDX-SC01) but you can use any commercially
available product. Use a cable with lead wires that have a wire diameter of AWG24 to 28. When using the cable
gland wiring method, use a cable with a φ 4.5 to 6.5 mm diameter.
*When providing your own, strip one end of the cable as shown below.
Mounting Hole Dimension Diagram
The position of the mounting holes is different between using M4 bolts and M3 bolts.
When using M4 bolts: φ4 (3 places)
When using M3 bolts: φ3 (3 places)
When using M4 bolts: φ40
When using M3 bolts: φ30
NOTICE
70 mm
Product Front
Wire Distribution Hole
Product Outer Dimension
Nameplate Location
25
7. Operation
ボルト
取付穴
ナ ット
（ 3 ヶ 所）
(φ12)
M4
M3
(Unit: mm)
ガイ ド 円
4
40
φ
φ
φ
3
φ
30
（ 単位 ： mm）
Advertisement
Table of Contents
