Replacing Mounting Bolts (M4 → M3) On The Main Unit; Detaching The Terminal Block Connector - Patlite WD PRO Series Instruction Manual

Wireless Data Communication System - WD PRO Series Instruction Manual
How to Attach the Pole Bracket and Direct Mount Bracket
❶
Use nuts in 3 places to affix the pole bracket
and direct mount bracket.
Recommended Torque
0.6N･m
7.1.2 Replacing Mounting Bolts (M4 → M3) on the Main Unit
M4 bolts are attached to the direct mount bracket by factory default. When using M3 bolts to attach this product,
follow the instructions below to replace the M4 bolts with M3 bolts.
❶
Remove the waterproof packing at the bottom of
the direct mount bracket.
❷
Detach the M4 nuts (3 locations) and M4 bolts
(3 locations) with a nut driver.*
* Criteria: 7mm across, outer dimension of socket 11 mm
or less
❸
Detach the M3 nuts (accessory, 3 locations)
and M3 bolts (accessory, 3 locations) with a nut
driver.*
* Criteria: 5.5 mm across, outer dimension of socket
9 mm or less
Recommended Torque
0.6 N•m (approximate)
❹
Attach the waterproof packing.
Caution: When attaching the waterproof packing, pay
close attention to set the correct orientation and
cause no damage. This will lower waterproofing
performance. Failure to follow this instruction
could result in product failure.

7.1.3 Detaching the Terminal Block Connector

■Attach
View of the body from the bottom
Push the lever up
With its levers pushed up,
push the terminal block
connector into the body.
When pushing the terminal
block connector in place,
the lever temporarily moves
down, before it moves back
up and locks in place.
31
Pole Bracket
M4 bolt
❷ ❸
■M3 Bolt Mounting Position
❷ ❸
M4 nut
Cable gland side
Waterproof gasket
* This illustration presents an overview of installation and
does not reflect the installation status at each step.
■Detach
Terminal Block Connector
7. Operation
Direct Mount Bracket
❶
Nut (M4)
M3 bolt
Use the inner holes (3 locations).
Direct Mount Bracket
M3 nut
❶❹
As illustrated, lower the
levers on the left and right
sides of the terminal block
connector to release the
lock, then pull out the termi-
nal block connector.