Wiring Rs-232C Cable From Cable Gland - Patlite WD PRO Series Instruction Manual

Wireless Data Communication System - WD PRO Series Instruction Manual

7.1.1.2 Wiring RS-232C Cable from Cable Gland

❶
In the mounting location, drill holes for mounting
and wiring the product.
☞ Mounting Hole Dimension Diagram(P.25)
* When using a pole bracket and pole, drilling holes is
70 mm
unnecessary.
70 mm
❷
Rotate the body counterclockwise and detach
from the direct mount bracket.
❸
Use nuts to secure the direct mount bracket in
the mounting position.
Recommended Torque
0.6 N•m (approximate)
☞ 7.1.2 Replacing Mounting Bolts (M4 → M3) on the
Main Unit(P.31)
*Do not secure when using a pole bracket and pole.
❹
Pass the wires (gray or black) through the wire
distribution hole.
* When using a pole bracket and pole, refer to "7.1.1.4
Wiring Method When Using Pole Bracket and Pole
(Accessories)( P.30)".
❺
Strip the RS-232C cable's lead wires.
70 mm
❻
Pass the cap through to the RS-232C cable, and
push in from the cable gland.
❼
Wire the RS-232C cable to the terminal block
connector and attach to the body.
☞ 7.1.3 Detaching the Terminal Block
Connector(P.31)
❽
☞ 7.1.4 WDB-DB0S wiring(P.32)
Tighten the cap clockwise on the insulation
portion of the RS-232C cable, with 5 mm of
the insulation portion protruding from the direct
mount bracket.
Recommended Torque
0.6 N•m (approximate)
❾
Attach the body to the direct mount bracket,
reversing the steps for detaching.
❿
If required, apply sealant around the mounting
and wire distribution holes.
Strip 6 to 7 mm
Strip 6 to 7 mm
Strip 6 to 7 mm
Caution: Attaching using any
other method than that
shown above may reduce
waterproofing performance.
Body
Body
❷
❷
Direct Mount
Direct Mount Bracket
Bracket
❹
❹
Body
❸
❸
❷
* This illustration presents an overview of installation and
does not reflect the installation status at each step.
* RS-232C cable is not included.
■ Fixed position of RS-232C sheathed cable
❽
■ Fixed position of RS-232C sheathed cable
❽
Direct Mount
Bracket
Caution: If the rubber bushing in the cable gland comes off,
carefully re-attach to return it to its original state.
❹
When using the SZK-003W wall bracket
(accessory), wiring from the cable gland is not
❸
possible.
28
7. Operation
❾
❾
Terminal Block Connector
Terminal Block Connector
(accessory)
(accessory)
❺❼
❺❼
Cable gland
Cable gland
❻
❻
Cap
Cap
(accessory)
❶
(accessory)
❶
❾
* Maximum board
thickness:7 mm.
Terminal Block Connector
(accessory)
❺❼
Cable gland
❻
about 5 mm
about 5 mm
Cap
CAUTION
(accessory)
❶