Routine Maintenance - H.C Duke & Son Arby's Electro Freeze Compact Series Operator's Manual With Replacement Parts List

12

Routine Maintenance

Electro Freeze recommends the following
schedule to help maintain your equipment
in like-new operating condition. Take the
time to learn and perform these routine
procedures and receive in return many
years of valuable service from your
freezer. Protect your investment.
1.
sanitize, air dry, reassemble and sanitize
all parts that come into contact with the
mix or product.
2.
with sanitizing solution.
3.
with the appropriate brushes.
3.
lubricate all seals and O-rings as
instructed that come into contact with
mix. Replace any O-ring that is worn,
torn, or loose-fitting.
4.
freezer to remove any splattered mix.
5.
of the product.
185260
DAILY
Disassemble, wash, rinse,
CAUTION
To prevent bacteria growth,
remove all O-rings when
cleaning. Failure to do so could
create a health hazard.
Clean and sanitize syrup lines
Clean the cylinder and drain tube
Upon cleaning, inspect and
Wipe all exterior surfaces of the
Check overrun and temperature
ELECTRO FREEZE Shake Model CS704
1. Carefully inspect all parts for
wear including, seals, O-rings, mix
transfer tube and blades.
2. Replace as required.
Replace blades if worn 3/16" or
more.
3.
drive shaft for wear.
GOOD SHAFT
TANG
A worn coupling will have a nonparallel
shape on the drive opening.
4.
as necessary. After cleaning apply spray
adhesive, p/n HC162548.
WEEKLY
Check the beater tangs and
Check the air filter and clean
35