H.C Duke & Son Arby's Electro Freeze Compact Series Operator's Manual With Replacement Parts List page 52

ELECTRO FREEZE Shake Model CS704
13 Troubleshooting Charts
PROBLEM PROBABLE CAUSE
Product dispenses slowly out of
dispensing head.
Compressor and beater motor
operates only when dispensing.
Compressor will not start -
hums intermittently (cycling on
overload)
NOTE: Contact your authorized Electro Freeze distributor for instructions prior to
warranty compressor replacement.
Keep your freezer in excellent condition. Always contact your Electro Freeze distributor
for replacement parts and maintenance scheduling.
42
1. No product in hopper.
2. Product too cold.
3. Mix feed tube not open.
1. Defective torque control.
1. Improperly wired.
2. Low line voltage.
3. Open start capacitor. (Single
phase only)
4. Defective compressor
— continued
REMEDY
1. Fill hopper.
2. See "Dispensed product too
hard."
3. Check mix feed tube setting.
1. Contact your Electro Freeze
Distributor for service.
1. Contact your Electro Freeze
Distributor for service.
2. Ask power company to
increase voltage to not less
than 10% below dataplate
rating or have transformer
installed. Have wire checked
for inadequate wire size.
3. Contact your Electro Freeze
Distributor for service.
4. Contact your Electro Freeze
Distributor for service.
QUALITY PARTS
PROTECT
YOUR
EQUIPMENT
185260