Draining Product From Freezer - H.C Duke & Son Arby's Electro Freeze Compact Series Operator's Manual With Replacement Parts List

ELECTRO FREEZE Shake Model CS704
9.2

Draining Product from Freezer

NOTE: It is your responsibility to be
aware of and conform to the requirements
for meeting local, state, and federal laws
concerning the frequency of cleaning and
sanitizing the freezer.
To remove frozen product from the
cylinder, perform the following steps:
1. Remove the flex shaft cover.
2. Place the selector switch in the
"CLEAN" position.
3. Place a clean, sanitized container
under the dispensing nozzle on the drip
tray.
4. Remove the mix feed tube from the
hopper. (See figure 9-3).
5. Disconnect the syrup lines.
6. Twist and pull down the mixing
chamber removing it from the head.
7. Disconnect the mixer shaft by
releasing the coupling while pulling on the
bottom.
8. Take parts to sink.
9. Place a clean, sanitized container
under the dispensing nozzle on the drip
tray. Dispense the product until the mix
is removed. Close the plunger. Place the
selector and syrup switches to "OFF" and
continue dispensing product until it quits
flowing and . If local health codes permit,
cover the rerun product container and
place it in the cooler. (See 10.2 General
Information - Rerun).
10. Pour 2 gallons of cold water into
the hopper. Place the selector switch to
"CLEAN" and dispense the cold water.
DO NOT use hot water. Damage to the
freezer could occur.
28
CAUTION
To avoid contact with moving parts,
deactivate spinner by removing
flex shaft cover. Spinner will not
operate with cover removed.
Important:
11. Follow with 2 gallons of warm
water and repeat until the freezer
dispenses clear water. With most of the
water dispensed, place selector switch in
the "OFF" position and drain off remaining
water.
12. Prepare 2 gallons (7.6 liters) of
sanitizing solution in a container. Sanitizing
solution must be mixed according to
manufacturer's instructions to yield 100
ppm available chlorine solution (example:
Stera-Sheen Green Label).
13. Pour all the sanitizing solution into
the hopper pan. Using a clean brush scrub
the hopper walls.
14. Place the selector switch to the
"CLEAN" position and allow the beater to
run for 5 minutes.
15. Place an empty container under
the dispensing head. Drain the sanitizing
solution from the cylinder by slowly pulling
down on the dispense handle. Open
and close the handle several times while
draining.
16. With most of the sanitizing solution
drained, Place the selector switch to
the "OFF" position and drain remaining
solution from the freezer and close the
plunger.
17. Proceed to sections 6
DISASSEMBLY AND CLEANING,
7 ASSEMBLY AND 8 STARTUP
INSTRUCTIONS.
Tube-Mix
Tube-Mix Feed
Feed
O-Ring
O-Ring
Figure 9-3
O-Ring
O-Ring
Insert-Assy.
Insert-Assy. Mix
Feed
Mix Feed
185260