Uncrating And Inspection; Installation - H.C Duke & Son Arby's Electro Freeze Compact Series Operator's Manual With Replacement Parts List

ELECTRO FREEZE Shake Model CS704
2.1

Uncrating and Inspection

When the unit is received and while
the carrier is still present, inspect the
shipping carton for any damage that
may have occurred in transit. If the
SHOCKWATCH
or the carton is broken, torn, or punctured
note the damage on the carrier's freight
bill and notify the carrier's local agent
immediately. Also note on the freight bill.
2.2

Installation

1. This freezer is designed for indoor
use and must be protected from outdoor
weather conditions.
2. This freezer requires a potable
water connection for the rinse line. The
water inlet is located at the back of the
freezer next to the power supply. A 3/8"
MPT water inlet connector will be needed.
2
CAUTION
Be sure to properly
support the machine
when removing bolts and
installing legs or casters.
label indicates red and/
®
CAUTION
All materials and connections
must conform to local
requirements and be in
compliance with the National
Electrical Code (NEC).
CAUTION
Tip Hazard. Front side of freezer
must remain positioned on door
side of cart. DO NOT reverse
position of freezer on cart.
1. Remove the carton from the pallet,
and move the machine as close as
possible to the permanent location.
2. Remove the shipping bolts on the
bottom of the freezer and remove the
freezer from the pallet.
CAUTION
Use caution when moving the
freezer to avoid a tip hazard.
3. A minimum 3-inch (7.6 cm) air
space is required on both sides and back
of the freezer for adequate ventilation.
4. Test the operation of the head and
flex shaft cover safety switches prior to
placing the freezer in service. See Section
12, Routine Maintenance, Monthly.
185260