Rinse Switch; Spinner Motor Fuse; Lexible Spinner Shaft; Reset -Circuit Breaker - H.C Duke & Son Arby's Electro Freeze Compact Series Operator's Manual With Replacement Parts List

5 Operator Controls
5.2

Prime / Calibrate

This push button switch is used for
priming and calibrating the flavor syrups.
With the syrup switch in the "ON" position,
the selector switch (5) in "AUTO" and
a flavor selection (8) made, pressing
this button will activate the pump for
that flavor to flush and prime the flavor
delivery line and to allow calibration of the
syrup flow.
5.3 Reset - Circuit Breaker Spinner Motor (3)
This control protects the spinner motor
against failure from an overload condition
by automatically shutting it down. To
restart wait 2-3 minutes, then depress the
reset button.
5.4 Syrup Pump Fuse
This holds the AGC fuse for the syrup
pumps.
5.5 Reset — Circuit Breaker Beater Motor (5)
This control protects the beater motor
against failure from an overload condition
by automatically shutting down the
freezer. To restart properly, turn the
SELECTOR switch (5) to "OFF", wait 2-3
minutes, then depress the reset button
and turn the SELECTOR switchback to
the "AUTO" or "CLEAN" position.
5.6

Selector Switch (6)

This three-position switch controls the
operating mode of your freezer.
a.
position operates the beater only (no
refrigeration). Always use this mode
when performing cleaning and sanitizing
operations.
b.
position the beater motor and refrigeration
system will not operate.
185260
"CLEAN" (left) — This
"OFF" (center) — In this
ELECTRO FREEZE Shake Model CS704
— continued
(2)
If the circuit breaker trips frequently,
your spinner mechanism and circuitry
should be checked. Contact your
Electro Freeze Distributor.
4
If the circuit breaker trips frequently,
your freezer should be checked for
proper product temperature, overrun
and voltage. Contact your Electro
Freeze Distributor.
Do not use the "FREEZE" position with
water or sanitizer in the cylinder — the
freezer will be damaged.
c.
position activates both the beater motor
and refrigeration unit. This is the normal
operating position which will maintain a
cylinder temperature of 26° to 28°F (-3° to
-2°C).
Important:
Important:
Important:
"AUTO" (right) — This
11