Daily Procedures; Night Or Idle Operation; General Cleaning - H.C Duke & Son Arby's Electro Freeze Compact Series Operator's Manual With Replacement Parts List

ELECTRO FREEZE Shake Model CS704
9
9.1

Night or Idle Operation

9.1.1
1. Remove the spinner flex shaft cover
assembly (1) in preparation to disassemble
the shake mix chamber (9).
SAFETY NOTE: Removal of the flex shaft
cover disables the spinner motor.
2. Disconnect the syrup lines and
water rinse line from the mix chamber.
3. Remove the mix chamber and set
aside for cleaning.
4. Disconnect the flex-shaft from
the spinner shaft (taking care not to drop
the spinner shaft which will fall out of the
plunger), remove the spinner shaft from the
shake head.
5. Prepare a container of sanitizing
solution. Sanitizing solution must be mixed
according to manufacturer's instructions to
yield 100 PPM strength chlorine solution.
(example: Stera-Sheen Green Label). Use
warm water (100-110°F or 37-43°C). Fill the
wash bottle with sanitizing solution.
6. Using a brush and bottle of
sanitizing solution wash down the bottom of
the shake head and plunger, being sure to
clean the plunger spinner shaft hole with a
brush.
7. Using the bottle of sanitizing
solution.
a.
plunger, and plunger spinner shaft hole
c.
syrup line connector. Also spray the end of
the connector for the water line.
d.
a brush to clean the center bore as well as
each of the syrup holes.
e.
brush to clean the paddle holes.
f.
chamber and spinner shaft with clean
sanitizing solution.
26

Daily Procedures

General Cleaning

rinse down the head, end of the
spray out the ends of each
wash the mix chamber using
wash the spinner shaft using a
rinse off the cleaned mix
Figure 9-1
8. Set parts aside to dry.
9. Leave shake mix system dis-
assembled overnight and re-assemble prior
to the next use. See Assembly Section 7.
10. If your location is open 24 hours,
system must be cleaned once a day, we
recommend cleaning steps 1 through 11 in
the morning or other slow period.
185260