H.C Duke & Son Arby's Electro Freeze Compact Series Operator's Manual With Replacement Parts List page 17

4 Part Names and Functions
The following part names and descriptions refer to figure 4-1.
1.) COVER - ASSY FLEX SHAFT: Protects
from accidental contact with rotating
shaft. Must be in place to operate.
2.) O-RING - HEAD: Seals the head to the
freezing cylinder. Must be lubricated.
3.) BUSHING - BEATER BEARING: Holds
the beater in place at the front of the
cylinder. Must be inserted into the
head and lubricated before assembly.
4.) KEEPER - ASSY SPINDLE: Secures
the handle to the head.
5.) HEAD - ASSY. W/RETAINERS 4
FLAVOR: Encloses the freezing
cylinder and provides an opening for
product to be dispensed.
6.) QUICK CONNECT WITH SHUT OFF:
Allows syrup line to be removed from
the mix chamber.
7.) O-RING - SYRUP LINE: Prevents syrup
from leaking.
8.) SHAFT - ASSY MIX: Mixes flavor into
shake mix.
9.) CHAMBER - MIX: Delivers syrup to the
shake mix.
10.) O-RING - CHAMBER: Prevents mix
from leaking. Lightly lubricate.
11.) HANDLE - ASSY COMPLETE: Opens
and closes the plunger to start and stop
the flow of product from the freezer.
12.) O-RING - PIVOT POST: Holds the pivot
post in place. Lightly lubricate.
13.) POST - PIVOT: Holds the handle in
place.
14.) PLUNGER - DISPENSING: Seals the
product opening in the head when
closed. Allows product to flow when
open.
185260
ELECTRO FREEZE Shake Model CS704
15.) BUSHING - MIXER SHAFT: Holds the
mixing shaft in place. Prevents wear
on plunger.
16.) ROD - ACTUATOR: Starts the freezer
when dispensing. Must be in place
before product can be dispensed.
17.) O-RING - PLUNGER-LOWER
18.) O-RING - PLUNGER-LOWER: Seals
the plunger in the head. Must be
lubricated to seal and slide properly.
19.) SHAFT - FLEXIBLE W/CASING 16-
1/2: Spins the mix shaft.
20.) CONNECT - ASSY DRIVE: Quick
connector used to connect or
disconnect the flexible shaft from the
mix shaft
— continued
7