H.C Duke & Son Arby's Electro Freeze Compact Series Operator's Manual With Replacement Parts List page 31

7 Assembly
in the replacement parts section of this
manual. Install the head o-ring (2) into the
groove on the back of the dispense head
(5),
plunger (14). Lubricate the o-rings.
pivot post (13). Lubricate o-rings lightly.
Insert pivot post into the head so the
holes are toward the back.
(15) into the plunger (14).
head (5) just past the top o-ring with the
slot facing back. Turn slot slightly to the
left and hook handle (11) into the slot.
With handle in the slot turn the slot to the
back.
handle (11), pivot post (13) and head (5)
until it locks in place.
the beater bearing bushing (3) and place
in the head (5) making sure to align
bushing key into head slot, as shown in
figure 7-5.
Match the key on the bushing. Make
sure the key aligns with the slot.
Failure to install the bushing properly
in the dispensing head will damage
the head.
Figure 7-5 Head Bushing
185260
— continued
6. See figure 7-4 and o-ring chart
7. (Install the o-rings (17, 18) on the
8. Install the o-rings (12) onto the
9. Install the mixer shaft bushing
10. Install the plunger (14) into the
11. Place the keeper (4) through the
12. Lubricate the inside surface of
Important:
ELECTRO FREEZE Shake Model CS704
13. Install the dispensing head
onto the freezer by tilting the top of the
head towards you, aligning the studs
with the holes in the head, and sliding
toward the freezer. As you push the head
towards the freezer, carefully rock it into
place, and align the shaft with the drive
coupling.
14. Tighten the hand knobs
simultaneously, finger-tight only.
Excessive force will damage the head.
Do not use tools to tighten.
15. Insert mixing shaft (8) into the
bottom of the head (5) with mixer paddle
towards the bottom. Pull back the sleeve
on the end of the flexible spinner tube
in the switch box and insert mixing shaft
into tube, turning until it snaps into place.
16. Install the o-ring (10) by pushing
it into groove in the mixing chamber (9).
Lightly lubricate the o-ring. Install the mix
chamber on to the bottom of the head
by placing over bolts and turn to lock in
place.
17. Install the actuator rod (16) by
placing one end into hole in the bottom
of the switch box and the other end in
the indent in the plunger behind the flex
shaft.
18. Place flex shaft cover (1) on top
of head using bolts to lock in place.
The freezer will not dispense product
without the flex shaft cover in
place.
19. Install the five o-rings (7) on
quick connect fittings (6) on the mix
chamber. Lightly lubricate o-rings..
20. Push each syrup line quick
connect (6) onto fitting of the mixing
chamber (10).
Important:
Important:
—continued
21