H.C Duke & Son Arby's Electro Freeze Compact Series Operator's Manual With Replacement Parts List page 50

ELECTRO FREEZE Shake Model CS704
13 Troubleshooting Charts
PROBLEM PROBABLE CAUSE
Unit does not operate.
Mix or water leaking from drain
tube to drip tray.
Mix leaking at dispensing head.
Dispensed product too soft.
(Product temperature above
28°F [-2.2°C] )
40
— continued
1. Freezer unplugged.
2. Fuse or breaker blown at
main disconnect.
3. Actuator rod not installed.
4. Off on high pressure cut-out
control.
5. Circuit breaker tripped.
6. Faulty selector switch.
7. Disconnected or broken wire
in electrical circuit.
1. Damaged beater shaft seal
or installed improperly.
1. Faulty head o-ring.
2. Head not properly installed.
3. Faulty Plunger o-ring or
wrong o-ring in wrong o-ring
grove.
1. Dirty or blocked condenser,
restricted air flow.
2. Torque control not set firm
enough.
3. Component failure.
4. Leak in refrigeration system
resulting in little or no
refrigeration.
REMEDY
1. Plug in freezer.
2. Make sure your freezer is
connected to a separate
circuit independent from any
other electrical equipment.
Have technician check fuse
or breaker size and check for
low voltage; if not within 10%
of nameplate rating call power
company.
3. Install actuator rod.
4. Water turned off or defective
water regulating valve. Check
water supply. (Water Cooled)
5. Reset. If trips again contact
your Electro Freeze
Distributor for service
6. Contact your Electro Freeze
Distributor for service.
7. Contact your Electro Freeze
Distributor for service.
1. Replace cup seal. Install
properly.
1. Replace o-ring.
2. Install head properly. Replace
o-ring if pinched.
3. Check the o-ring chart.
1. Unblock condenser or have
cleaned by your Electro
Freeze Distributor.
2. Contact your Electro Freeze
Distributor for service.
3. Contact your Electro Freeze
Distributor for service.
4. Contact your Electro Freeze
Distributor for service.
185260