Table of Contents
Advertisement
ELECTRO FREEZE Model CS600
10
Closing Procedures
10.1
Night or Idle Operation
Pin is in line with hole.
Look through top hole
in tube — you should
see clear through.
Figure 9-1
184596
Pin is not in line with hole.
Look through top
hole in tube — you
should see the inner
white plastic insert
tube blocking the
opening.
Mix Feed Tube Positions
1. In areas where state and local
health codes allow, product may remain in
the freezer overnight, leave the Selector
Switch in the "AUTO" position.
2. The plunger rod must be in place for
the unit to operate.
3. Clean all soiled surfaces with a
warm dish detergent solution.
4. Using the small brush supplied in
the spare parts kit, brush the bottom of the
plunger with a warm dish detergent solution,
then brush with sanitizing solution.
5. Turn the mix feed insert to the
"CLOSED" position as shown in figure 9-1.
6. Check mix level in hopper to ensure
that there is enough mix to keep the
indicator light off, add mix if necessary. Do
not dispense product when the mix feed
insert is in the "CLOSED" position.
7. Before serving from the machine
brush the plunger opening with sanitizing
solution and "OPEN" the mix feed insert and
fill the hopper with mix (figure 9-1).
17
Advertisement
Chapters
Table of Contents
