Table of Contents
Advertisement
ELECTRO FREEZE Model CS600
6
Operator Controls
The following paragraphs describe the
operator controls and indicators. Refer to
figure 6-1 for location of these controls and
indicators on the Model CS600 freezer.
NOTE: The plunger rod must be in place
before the freezer will operate in "DAY",
"NIGHT", or "CLEAN" position.
Test operation of the head
switch prior to placing the
freezer in service. See Section
12, Routine Maintenance,
Monthly.
6.1
Selector Switch 1
This three-position switch selects the
mode of operation of the freezer.
operates the beater only (no refrigera-
tion). Always use this mode when
performing cleaning and sanitizing
operations.
the beater motor and refrigeration
system will not operate.
6.2
Day– Night Switch
ture thermostat controls the system
refrigeration to maintain the product
serving temperature between 18
(-8 to -6°C). This is the normal operating
position.
6.3
"ADD MIX" Indicator Light 3
When lit, this light indicates the mix in
the hopper is at a low level and should
be refilled as soon as possible. Always
maintain at least 2 inches (5 cm) of mix
in the hopper. For best operating results
keep hopper full.
184596
CAUTION
a. "CLEAN" (left) — This position
b. "OFF" (center) — In this position
2
a. "DAY" (left) — The low tempera-
Figure 6-1
Important:
Do not use the automatic position
with water or sanitizer in the cylinder
or hopper — the freezer will be dam-
aged.
c. "AUTO" (right) — This position
activates both the beater motor and
refrigeration unit. This is the normal
operating position.
b. "NIGHT" (right) — This energy
saving mode will reduce product agita-
tion. The freezer will automatically cycle
°
–21°F
to maintain temperatures below 41
C). Use this position when the freezer
will not be in use for periods of more
than an hour.
If proper mix level is not maintained,
a freeze-up may occur and damage
the freezer.
º
F (5
Important:
7
l
º
Advertisement
Chapters
Table of Contents
